|
|
Double Rails
|
|
New Low Cost Series 500 Linear Double Rail System From Techno-Isel Offers An Enclosed Aluminum Housing
Quote Request
|
|
New Hyde Park, New York --
The New Series 500 Linear double rail system from Techno-Isel offers
affordable precision motion for a variety of heavy load positioning
applications. This extremely low cost system has a maximum speed of up
to 5 m/sec.
These rails, identified as the 500 Series, consist of 2 sets of double
precision ground 12 mm diameter Cf53 steel shafts hardened to RC 62±2
that can accommodate newly patented roller and bearing carriages. The
shafts are pulled together by the unique shaped support blocks,
ensuring that they are parallel to <0.02 mm/1m. They are stocked
in16 sizes from 400 mm to 3000 mm. The larger middle cavity is
designed to house a wide variety of items including wiring, cylinders,
screws, or motors.
This Series 500 system can run with both the newly patented Techno
roller carriage 2, bearing carriage 2, or bearing carriage 4 designs.
The more economical roller carriage 2 consists of a ground and
hardened steel plate 110 x 65 x 6 mm with four M6 threaded holes on a
50 mm grid. Four precision rollers, 21 mm in diameter, are on each
plate. Each roller has two sealed bearings which are lubricated for
life. Two of the rollers have eccentric mounting to allow for easy
preload and clearance adjustment. They have a travel speed of up to 10
m/sec. with very quiet operation. The Bearing Carriage 2 consists of a
ground and hardened steel plate 80 x 60 x 36 mm with four M6 holes for
threaded fastening and two 5h7 diameter holes for dowel pins. Each
carriage has 4 re-circulating raceways with 3.5 mm diameter ball
bearings. The unit is equipped with wipers and lubrication ports. The
maximum rate of speed is 5 m/sec. The bearing carriage 4 is a single
piece body constructed of ground & hardened steel. There are three
M6 tapped mounting holes on the top of the carriage. The bearing also
has a 28 mm diameter H7
precision hole through the body for mounting a ball screw, ball nut,
pneumatic cylinder, belt or other drive mechanism.
|
|
|
