• Guide rails consist of two precision ground Ø12 mm steel shafts, with M5 threaded holes spaced 100 mm apart. Shaft is hardened to RC 62 + 2
• The two shafts are pulled together by the mounting block design, ensuring they are parallel to < .02 mm / 1 m and easy assembly
• The aluminum mounting blocks have two holes spaced 28 mm apart for easy mounting
• The mounting blocks can be set at increments of 100 mm depending on the size of the load
• Extremely low cost
• Can use Roller Carriage 2, Bearing Carriage WS4 or Bearing Carriage 4
• The steel shafts can be staggered and built up to provide virtually any length of travel

• Max linear speeds of up to 10 m/sec
• Example of Rail Assembly (as shown in picture below) requires: 
  2 x HL5727M3120500 Tapped Shafts 
  5 x HL5400M221501 mounting blocks

*This isel Linear System is patented