techquestions@techno-isel.com
41
Series 2 Double Rails
*
FEATURES
• Guide rails consist of two precision ground Ø12
mm steel shafts, with M5 threaded holes spaced
100 mm apart. Shaft is hardened to RC 62 + 2
• The two shafts are pulled together by the sup-
port block design, ensuring they are parallel to
< .02 mm / 1 m and easy assembly
• The aluminum support blocks have two holes
spaced 28 mm apart for easy mounting
• The support blocks can be set at increments of
100 mm depending on the size of the load
• Extremely low cost
• Can use Roller Carriage 2, Bearing Carriage
WS4 or Bearing Carriage 4
• The steel shafts can be staggered and built
up to provide virtually any length of travel
• Note that the individual shafts and mounting
blocks are sold separately
• Maximum linear speeds of up to 10 m/sec
• Example of Rail Assembly (as shown in
picture below) requires: 2 - HL5727M3120500
and 5 - HL5400M221501
NOTE: Actual length is 2 mm less than nominal length.
Tapped Shaft
NOTE: Mounting screws for steel shaft are included with block.
* This isel Linear System is patented.
54
Typ 100 mm
44
Ø44
12
Catalog Number
HL5400M221501
Requires: (as shown)
(2) HL5727M3120500 and
(5) HL5400M221501
Length Catalog Number
mm
400
HL5727M3120400
500
HL5727M3120500
600
HL5727M3120600
700
HL5727M3120700
800
HL5727M3120800
900
HL5727M3120900
1000
HL5727M3121000
1100
HL5727M3121100
1200
HL5727M3121200
1300
HL5727M3121300
1400
HL5727M3121400
1500
HL5727M3121500
1800
HL5727M3121800
2000
HL5727M3122000
2500
HL5727M3122500
3000
HL5727M3123000
Mounting Block
